Hospitality
Hotel IT and surveillance systems in Chandigarh
Guests judge your Wi-Fi within ten minutes of checking in. We separate guest traffic from your billing and PMS entirely, cover the areas your insurer asks about, and put reception on a phone system that does not drop calls.
What makes this sector different
The pressure you are actually under
Buying decisions in this sector are driven by these, not by a feature comparison.
- 01
Guest Wi-Fi is now reviewed publicly alongside the rooms, so weak coverage in the far wing turns into a rating that costs future bookings.
- 02
Payment terminals and property management systems handle cardholder and guest identity data, which has to sit apart from the network guests are on.
- 03
The building is occupied every day of the year, so there is no shutdown period in which to cable or rewire.
Typical deployment
What we install for hospitality
Concrete, not aspirational. This is the equipment list a site like yours ends up with.
Guest Wi-Fi with per-room coverage, isolated completely from hotel systems
PMS and POS terminals on a protected network with card-data separation
Surveillance across entrances, lobby, corridors, parking and back-of-house
IP telephony with room extensions, wake-up calls and reception queueing
Cabling that survives a live building with guests in it
Redundant internet so a link failure does not stop check-ins
Services involved
What this is built from
Networking & cabling
Bad cabling shows up years later as a fault nobody can trace. We label every run, document every port and leave you a rack you can work in without a torch.
Read moreVoIP & IP telephony
Move your extensions onto the network you already own. Calls route between your Chandigarh office and your plant at no line cost, and a missed call leaves a record.
Read moreIP surveillance
A camera is only useful if the footage is admissible and someone can find it. We survey the site, choose lens and mounting for the shot you actually need, and hand over a system your staff can search.
Read moreNetwork security
The firewall at your edge decides what reaches your staff. We configure it against your actual traffic, review the rules quarterly, and tell you which of them stopped something.
Read moreAMC & managed IT
One contract, a named engineer and a response time you can hold us to. We keep an asset register from day one, so you always know what you own and what is out of warranty.
Read moreQuestions we get asked
Hospitality: straight answers
How do you keep guest Wi-Fi away from hotel systems?
- By putting guests on their own VLAN with client isolation and no route to internal systems. Guests reach the internet and nothing else, so a compromised laptop in room 204 cannot see your PMS, your POS or another guest's device.
Why is Wi-Fi weak in some rooms?
- Hotel construction is the usual cause — brick and concrete between rooms, plus lift shafts and service risers, absorb the signal. Corridor-mounted access points spaced from a survey fix it far more reliably than adding power to existing units.
Can cabling be done with the hotel open?
- Yes. Work runs floor by floor and wing by wing, in the low-occupancy hours your duty manager nominates, with each section tested and handed back before the next begins. No block loses service overnight.
Which areas should hotel cameras cover?
- Entrances, reception, lobby, lift lobbies, corridors, parking and back-of-house receiving, as a baseline. Guest room interiors are never covered. Retention is set longer on entrances and parking, which is where insurers and police ask for footage.